Dante devices are connected via a network switch, which most often means a “star” topology – all devices are connected to a single central point, which minimizes the number of “hops” through which data must pass. Once routes are established with Dante Controller, a simple network of two Dante devices will work in a stand-alone fashion. Is it possible to make direct connections between Dante-enabled equipment? Many organizations will have fiber already in place from other projects and this can simply be re-used on a Dante network. Use a switch that supports fiber connections to send Dante data over a fiber optic cable.Įthernet is not copper or fiber based, it is independent of the cabling medium. Because Dante works with standards based networking technology, using fiber is simple. For purely 100Mbps networks, CAT5 may be used.ĭoes Dante work with Fiber Optic network cable? What type of Ethernet cable is recommended for Dante?Īs most Dante devices support gigabit Ethernet, Cat5e or Cat6 cable is recommended. If you have only one Dante-enabled device to connect to your computer, you may eliminate the switch and simply connect the two with a Cat5e or Cat6 Ethernet cable. Simply connect your Dante enabled devices to an Ethernet switch, using Cat5e or Cat 6 Ethernet cable, and then connect your computer to the same switch. (PDF)Ĭan I connect a Dante device directly to my computer?
0 kommentar(er)
